Filter
Top Products
DISASSEMBLY AND REASSEMBLY
The Evaporator fan motor in the arctic select
zone is located in the lower part of evaporator
cover.
1. Remove the screws(2 pieces)attached to
the Fan-Cover.
2. Separate the insulation covering the fan
by removing the sponge and tape.
3. Separate the housing terminal connected
to the fan, and lift up the fan.
EVAPORATOR FAN MOTOR IN ARCTIC SELECT ZONE
The Evaporator is located in the bottom of the
freezer
1. Take off the freezer partition in.
2. Disassemble the fan motor.
3. Disconnect the wire connector (Heater,
Bimental, and Thermistor).
4. Desolder the inlet and outlet tubes.
5. Remove the evaporator.
6. Take the same steps as above to confirm
the system.
Evaporator in Freezer
The evaporator fan is located in the lower rear
of the refrigerator. This fan circulates cold air
in the refrigerator.
1. Remove the screws(4 pieces) from the four
corners of fan bracket.
2. Take the fan motor assembly off.
Evaporator Fan Motor
Accumulator
Thermistor
Bimetal
5353