Filter
Top Products
DISASSEMBLY AND REASSEMBLY
1.First separate the two lamp- covers which are in the
upper part.
UPPER DUCTWORK
2. Unscrew the lower part and the center of the duct-work.
3. Unscrew (2 screws) the upper part of the evaporator
cover to take out the duct work by pulling.
4. Separate the sensor-cover in the lower part of duct
work. And then separate the housing terminals(lamp &
thermistor) and pull them out using both hands.
The Evaporator Fan Motor in the Fresh Select Zone is
located in the lower part of the cooling compartment.
1.Unscrew the fan-cover. (2 screws)
Evaporator Fan Motor in Fresh Select Zone
TM
2. Separate the insulation covering the fan by
removing the sponge and tape.
3. Separate the housing terminal connected to the
fan, and lift up the FAN.
screws
5757