Filter
Top Products
t= Remove the broiler pan and grid, oven
racks, utensils .o_.._o
and any foil that __
may be in the I[
oven.
2, Soil on the front
frame, i" inside ;
the oven, and
outside the door
gasket will need to be cleaned by hand.
Clean these areas with hot water, soap-fitted
steel wool pads or cleansers such as Soft
Scrub® to remove any soil. Rinse well with
clean water and dry.
3, Wipe up any heavy spillovers on the oven
bottom.
4, Do not clean the door gasket. The
fiberglass material of the oven door gasket
cannot withstand abrasion. It is essential
for the gasket to remain intact. If you notice
it becoming worn, frayed, or displaced on
the door, it should be replaced.
The door gasket _oRPANEL GASKET
is designed to
have a 5-6" gap
at the bottom of
the door. _
This allows for Doe,u,_
proper air circulation. It is normal for your oven
door to give the appearance of not having a
good seal against the range. This is due to the
gasket. The location of the gasket on the oven
door maintains a good seal and prevents any
heat loss.
Utensils should never be le#
in a self-clean cycle.
The oven racks may be
cleaned during the selbclean
cycle, but will lose their luster
and becem_ hard to slide, if you choose
to leave them in during the cycle, wiping
them down with vegetable oil after the
cycle will help them slide easier.
Al_vays make sure the oven light is off
during _he self-clean cycle _o prolong
the life of the bulb.
For the first clean cycle, vent the room
with an opened window or hood vent,
This will prevent the strong odor from
heating new parts.
o When the door locks, _-GC_ #GGB will
show in the display. The oven temperature wilt
need to drop below the locking temperature
before the door can be opened. The word
LGCK_ DGGB will go out in the display,
o If LOCK DGGR flashes in the display, the
door is not closed completely, simply press
on the door.
Clean only as touch-up between clean cycles.
Use dishwashing liquid, warm water, or
soap-filled steel wool pad. Rinse well after
cleaning and dry.
_EVE_ USE OVE_J CLEA_Ef_S _ O_
A_tOU_D AE#Y PART GF THE OVE_o
When cleaning, be sure not to bend or
displace the temperature sensor located on
the back wall of the oven.
t5 self-clean cycle continued