Sunbeam JS7300 Juicer User Manual


 
20
Fast Clean Up
Clean up is fast when done immediately after
juicing.
1. Immerse the juicer body and its parts in
warm water, then rinse clean under running
water.
2. Use a hard bristle tooth brush to remove
all pulp from the juice strainer; this is best
done under a tap with running water.
3. Wipe motor body clean with a damp cloth
or sponge.
Care and Cleaning
Note: Ensure that the juicer is unplugged
from the power outlet prior to cleaning.
Thorough cleaning
To clean the juicer strainer use the hard
bristle brush. Tough to get out fibres can be
softened by soaking. Any remaining vegetable
fibers can be brushed off with a dry brush
when the strainer is completely dry. Keep
your strainer clean. A partially clogged juicer
strainer reduces juicer efficiency.
All parts are washable in warm soapy water
except the motor body.
Dry parts with a towel or let them drip dry in
dish rack.
Important: Do not use chemical cleaners or
scouring powders on the juicer parts. These
products will damage the machine parts and
finish.
If there are vegetable stains, soak the
affected parts overnight in a solution of white
vinegar diluted with an equal amount of
water. As an alternative, try the same recipe
with bicarbonate of soda. Vegetable stains on
the juicing screw are normal.
Dishwashing
All parts of the Sunbeam Juice Life,
excluding the motor body, can be placed in
the dishwasher for effortless cleaning after
juicing.
Do not place juicer parts close to the heater
element in a dishwasher. If the heating
element is on bottom, place the juicer parts
on the top rack only.