Filter
Top Products
7
Heading
Before Use
After unpacking your Sunbeam Juice Life
Juicer, we recommend that you disassemble
the unit before using for the first time. Wash
all parts except the motor body in hot soapy
water. Rinse and dry immediately.
Important: Always ensure your juicer is
unplugged from the power outlet when not
in use, during assembling or whilst removing
parts.
1. Insert the juicing screw into the juicer
body, figure 8.
2. Then, add the following, figure 9;
a. Juice strainer (or blank strainer).
b. The strainer cap. Tighten it by turning it
to the left or anti-clockwise.
c. Finally, add the juicing end nozzle (the
one with the green washer) or any of
the other seven end nozzles. Tighten by
turning left or anti-clockwise.
3. Set the motor body on a dry, level surface.
Make sure the power cord is unplugged
during assembly.
4. Insert the juicer body and its gear shaft
into the motor body. Then lock the juicer
body by turning the locking nut clockwise,
figure 10.
[Insert drawing]
5. Insert the hopper onto the top of the
juicer body chute and slide both the juice
(small) and the pulp (bigger) containers
underneath the juicer body. The juice
container sits closest to the motor,
figure 11.
Assembling your Sunbeam
Juice Life