Filter
Top Products
21
Model 142 Troubleshooting Guide
Section 8 Troubleshooting Guide
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
1. No product being
dispensed.
a. Toggle switch in OFF
position.
a. Place toggle switch in the
AUTO position.
15
b. Inadequate level of mix i n
mix hopper.
b. Fill m ix hopper with mix.
15
c. Beater motor overloaded. c. Place the toggle switch in
the OFF position. Allow
the motor to cool. Reset
beater motor . Place the
toggle switch in the A UT O
position.
8
d. Unit unplugged at wall
receptacle.
d. Plug in power cord.
---
e. Tripped circuit breaker or
blown f use.
e. Place the circuit breaker in
the ON position o r replace
fuse.
---
f. Freezer door was
assembled incorrectly.
f. See “Operating
Procedures” for pr oper
installation.
10
g. Product is being drawn off
far in excess of freezer’s
capacity.
g. Stop drawing product and
allow unit to recover.
---
h. Feed tube incorrectly
installed.
h. Install feed tube according
to instructions in this
manual.
16
2. Machine will not operate i n
the AUT O position.
a. Unit unplugged. a. Plug in power cord.
---
b. Circuit breaker tripped or
fuse blown.
b. Place the circuit breaker in
the ON position o r replace
fuse.
---
c. Beater motor overloaded,
causing a loss of power to
the toggle switch.
c. Place the toggle switch in
the OFF position. Allow
the motor to cool. Reset
beater motor . Place toggle
switch in the AUTO
position.
8
3. Product i s too s tiff. a. The temperature c ontrol is
set too cold.
a. Call service technician.
---