Filter
Top Products
3
Model 142 To the Instal ler
130809
Electrical Hook- up Installation
For 60 Cycle, 1 PH, Supplied With Cord and Plug
This equipment is supplied with a 3- wire cord and
grounding type plug for connection to a single phase,
60 cycle, branch circuit supply. This unit must be
plugged into a properly grounded receptacle. The cord
and plug provided for 115/60/1 and208- 230/60/1 is 1 5
amp.; therefore the wall outlet must also be 15 amp.
Check the data label located on the rear of the freezer
for electrical specifications.
IMPORTANT: In order to secure the compressor and
to minimize vibration during shipment, two shipping
bolts have been added to the base pan of the unit.
Before ins tallation, these bolts must be removed.
Permanent wiring may be us ed if local codes require
it. Instructions for conversion to permanent wiring are
as follows:
IMPORTANT: This procedure must be
performed by a qualified electrician.
1. Be s ure the freezer is electrically disconnected.
2. Remove the appropriate panel and loc ate the
control box at the back of the freezer .
3. Remove the factory- installed c ord and strain
relief bushing.
4. Route incoming permanent wiring through 7/8”
(22 mm) hole in base pan.
5. Connect two power supply l eads, attach ground
(earth) wire to the grounding lug inside the
electrical box.
6. Be s ure unit is properly grounded before
applying power.
FOLLOW YOUR LOCAL ELECTRICAL CODES!
Refrigerant
In consideration of our environment, Taylor
uses only earth friendly HFC refrigerants. The HFC
refrigerant used in this unit is R404A. This refrigerant
is generally considered non-toxic and non-flammable,
with a n Ozone Depleting Potential (ODP) of zero ( 0).
However , any gas under pressure is potentially
hazardous and must be handled with caution. NEVER
fill any refrigerant cylinder completely with liquid.
Filling the cylinder to approximately 80% will allow for
normal expansion.
Use only R404A refrigerant that conforms to
the AHRI standard 700 specification. The use of any
other refrigerant may expose users and operators to
unexpected s afety hazards.
Refrigerant liquid sprayed onto the skin may
cause serious dam age to tissue. Keep eyes and skin
protected. If refrigerant burns should occur, flush
immediately with cold w ater. If burns are severe, apply
ice packs and contact a physician im mediately.
Taylor reminds technicians to be cautious of
government laws regarding refrigerant recovery,
recycling, and reclaiming systems. If you have any
questions regarding these laws, please contact the
factory Service Department.
W ARNING: R404A r efrigerant used in
conjunction with polyolester oils is extremely moisture
absorbent. When opening a refrigeration system, the
maximum time the system is open must not exceed 15
minutes. Cap all open tubing to prevent humid air or
water from being absorbed by the oil.