Filter
Top Products
4
Model 142To the Operator
131122
Section 2 To the Operator
Your freezer has been carefully engineered and
manufactured to give you dependable operation. If the
Taylor Model 142 is properly operated and cared for,
it will produce a consistent, quality product. Like all
mechanical products, this machine will require
cleaning andmaintenance. Aminimum amount of care
is necessary if the operating p rocedures outlined in
this manual are followed c losely.
This Operator’s Manual should be read
before operating or performing any maintenance on
your equipment.
Your Taylor freezer will NOT eventually compensate
and correct for any errors during the set- up or filling
operations. Thus, the initial assembly and priming
procedures are of e xtreme importance. It is important
that the personnel responsible for the equipment’s
operation study this manual in order to be properly
trained.
In the event you should r equire technical assistance,
please contact your local authorized Taylor Distributor .
Note: Your Taylor warranty is validonly if the parts are
authorized Taylor parts, purchased from the local
authorized Taylor Distributor, and only if all required
service work is p rovided by an authorized Taylor
service technician. Taylor reserves the right to deny
warranty claims on units or parts if non- Taylor
approved parts or incorrect refrigerant were installed
in the unit, system modifications were performed
beyond factory recommendations, or it is determined
that the failure was caused by abuse, misuse, neglect,
or failure to follow all operating instructions. For full
details of your Taylor Warranty, please see the L imited
W arranty section in this manual.
Note: Constant research results in steady
improvements; therefore, information in this
manual is subject to change without notice.
If the crossed out wheeled bin symbol is
affixed to this product, it signifies that this product is
compliant with the EU Directive as well as other similar
legislation in effect after August 13, 2005. T herefore,
it must be collected separately after its use is
completed, and cannot be dis posed as unsorted
municipal waste. The user is responsible for returning
the product to the appropriate collection facility, as
specified by your local code.
For additional information regarding applicable local
laws, please contact the municipal facility and/or local
distributor.
Compressor Warranty Disclaimer
The refrigeration compressor(s) on this unit are
warranted for the t erm stated in the Limited Warranty
section in this manual. H owever, due to the M ontreal
Protocol and the U.S. Clean Air Act Amendments of
1990, m any new refrigerants are being tested and
developed, thus seeking their way into the service
industry. Some of these new refrigerants are being
advertised as drop- in r eplacements for numerous
applications. It should be noted that in the event of
ordinary service to this unit’s refrigeration system,
only the refrigerant specified on the affixed data
label should be used. The unaut horized use of
alternate refrigerants will void your Taylor compressor
warranty. It is the unit owner’s responsibility to make
this fact known to any technician he employs.
It should also be noted that Taylor does not warrant the
refrigerant used in its equipment. For example, if the
refrigerant is lost during the course of ordinary service
to this machine, Taylor has no obligation to either
supply or provide its replacement either at billable or
unbillable terms. Taylor does have the obligation to
recommend a suitable replacement if the o riginal
refrigerant is banned, obsoleted, or nolonger available
during the five y ear warranty of the compressor.
Taylor will continue to monitor the industry and test
new alternates as they are being developed. Should a
new alternate prove, through our testing, that it would
be accepted as a drop- in replacement, then theabove
disclaimer would become null and void. To find out the
current status of an alternate refrigerant as it relates to
your compressor warranty, call the local Taylor
Distributor or the Taylor Factory. Be prepared to
provide the Model/Serial Number of the unit in
question.