Filter
Top Products
18
Models 8752, 8756, 8757Important: To the Operator
Parts Identification for 8752, 8756, & 8757
Item
Description
1 Power Switch (Toggle)
2 Reset Switch
3 Mix Refrigeration Control
4 STANDBY Key
5 WASH Key
6 AUTO Key
7 PUMP Key
8 Mix Low Indicator
9 Mix Out Indicator
10 Heater Switch
Symbol Definitions
To better communicate in the International arena, the
words on many of our operator switches and buttons
have symbols to indicate their functions. Your Taylor
equipment is designed with these International
symbols.
=AUTO
=ON
=OFF
=MIXREF
= WASH
=PUMP
= STANDBY
=MIXLOW
= MIX OUT
=HEATERON
Power Switch
When placed in the ON position, the power switch
allows SOFTECH control panel operation.
Indicator Lights -
MIX LOW and MIX OUT
When the MIX LOW light begins to flash, it indicates
the mix tank has a low supply of mix and should be
refilled as soon as possible. When the MIX OUT light
begins to flash, it indicates the mix tank has been
almost c ompletely exhausted and has an insufficient
supply of mix to operate the freezer. At this time, the
STANDBY and AUTO modes are locked out and the
freezer shuts down. To initiate the refrigeration
system, add mix to the tank and press the AUTO key.
The freezer will automatically begin operation.
Reset Button
The reset button is located in the decorative plate
above the SOFTECH controls. The reset protects the
beater motor from an overload c ondition. Should an
overload occur, the reset mechanism will trip. To
properly reset the freezer, press the AUTO key to
cancel the cycle. Turn the power switch to the OFF
position. Press the reset button firmly. T urn the power
switch to the ON position. Press the W ASH key and
observe the freezer’s performance. Open the side
access panel to check if the beater motor is turning the
drive shaft in a clockwise (from operator end) direction
without binding.
If it is turning properly, press the WASH key to cancel
the cycle. Press the AUTO key to resume normal
operation. (For the Models 8756 and 8757, press the
AUTO key on both sides to resume normal operation.)
If the freezer shuts down again, contact a service
technician.
SOFTECH Control Operation
MIX REF
When the MIX REF key is pressed, the light comes on,
indicating the mix cabinet refrigeration system is
operating. (For the Models 8756 and 8757, there are
two touch- tone panels, one for each freezing cylinder.
The mix refrigeration system is controlled by the MIX
REF key found on the left panel. By pressing the AUT O
key on either side of the freezer, the MIX REF function
is automatically turned on.) The MIX REF function
cannot be cancelled unless the AUTO or STANDBY
mode is cancelled first.