Filter
Top Products
26
Models 8752, 8756, 8757Operating Procedures
Insert the mix inlet fitting into the hole in the base of the
liquid valve body.
Figure 24
Secure the pump parts in position by sliding the
retaining pin through the cross holes located at the
bottom of the pump cylinder .
Figure 25
Step 5
Assemble the flare line and suction line. Assemble the
weighted end into the suction line. Attach the mix
suction line to the barbed end of the mix inlet fitting and
allow the weighted end to hang free. (Note: The
suction line must fit tightly against the mix inlet fitting.)
Figure 26
Push both nuts back from the flare end and lightly
lubricate the underside of the plastic flare. This will
allow the nut to turn freely without twisting the tubing.
Attach one end of the flare line to the threaded fitting
on the lower side of the pump cylinder and allow the
other end to hang free.
Figure 27