Filter
Top Products
21
Models 8752, 8756, 8757 Operating Procedures
Install the drive shaft through the rear shell bearing in
the freezing cylinder and engage the hex end firmly
into the gear box coupling. Be sure the drive shaft fits
into the drive coupling without binding.
Figure 2
Step 2
Install the beater assembly. First check the s craper
blades for any nicks or signs of wear . If any nicks are
present, replace both blades. If the blades are in good
condition, install the scraper blade clips on the scraper
blades. Place the rear scraper blade over the rear
holding pin on the beater.
Note: The hole on the scraper blade must fit securely
over the pin to prevent costly damage.
Figure 3
Holding the rear blade on the beater, slide it into the
freezing cylinder half way. Install the front scraper
blade over the front holding pin.
Figure 4
Install the beater shoes.
Figure 5
Slide the beater assembly the rest of the way into the
freezing cylinder.
Make sure the beater assembly is in position over the
drive shaft. Turn the beater slightly to be certain that
the beater is properly seated. When in position, the
beater will not protrude beyond the front of the
freezing cylinder.
Repeat Steps 1 a nd 2 for the other side of the freezers
on the Models 8756 and 8757.