Filter
Top Products
32
Models 8752, 8756, 8757Operating Procedures
140306
Step 5
Place an empty pail beneath the door spout and open
the draw valve. With the prime plug still in the UP
position, press the PUMP key. This will allow the mix
to be pumped through the freezing cylinder and force
out any remaining sanitizer. When full strength mix is
flowing from the door spout, close the draw valve.
Figure 45
Step 6
When a steady stream of mix is flowing from the prime
plug hole in the bottom of the freezer door, press the
PUMP key to stop operation.
Step 7
Once the stream of mix stops flowing from the prime
plug hole, push down the prime plug. Rinse the prime
plug hole area with water. Remove the pail and discard
the mix and the sanitizer.
Figure 46
Step 8
Press the AUTO key. The MIX REF light will come on
indicating the mix refrigeration system is operating, the
AUTO light will come on indicating the main
refrigeration system is operating, and the PUMP light
will come on indicating the air/mix pump will operate
whenever mix is needed in the freezing cylinder.
Figure 47
Repeat Steps 1 through 8 for the other side of the
freezer on the Models 8756 and 8757.
When the unit cycles off, the product will be at the
correct viscosity.
Note: Keep the mix cabinet door closed except when
filling the mix tank and during the cleaning and
sanitizing procedures. Leaving the door open with the
mix refrigeration system on may cause the evaporator
to ice up and impair the mix cabinet refrigeration.
Closing Procedure
To disassemble the Models 8752, 8756 and 8757, the
following items will be needed:
S T wo cleaning and sanitizing pails
S Sanitized stainless steel rerun can with lid
S Necessary brushes (provided with freezer)
S Cleaner
S Single service towels
Draining Product From the
Freezing Cylinder
Step 1
Press the AUTO and MIX REF keys to cancel freezer
operation.
Step 2
Open the mix cabinet door and remove the mix storage
cover(s), mix probe(s), mix tank cover(s), and mix
tank(s). Empty the mix from the mix tank(s) into a
sanitized stainless steel rerun can.