Taylor C708 Freezer User Manual


 
14
Models C708 & C716Important: To the Operator
050628
If the beater motor is turning properly, touch the
WASH symbol
to cancel the cycle. Touch the
AUTO symbol
to resume normal operation. If the
freezer shuts down again, contact your authorized
service technician.
Air/Mix Pump Reset Mechanism
This reset button protects the pump from an
overload condition. Should an o verload occur, the
reset mechanism will trip. To reset the pump, press
the reset button firmly.
WARNING: Do not use metal objects to
press the reset button. Failure to comply may
result in severe personal injury or death.
Adjustable Draw Handle
These units feature an adjustable d raw handle( s) to
provide the best portion control, giving a better,
consistent quality to your product and controlling
costs. The draw handle(s) should b e adjusted to
provide a flow r ate o f 5 to 7-1/2 oz. (142 to 213 g.)
of product by weight per 10 seconds. To INCREASE
the flow rate, turn the screw CLOCKWISE. To
DECREASE the flow rate, turn the screw
COUNTERCLOCKWISE . (See Figure 10.)
+
-
10354
Figure 1 0
Operating Screen Descriptions
The fluorescent display located in the c enter of the
control panel is normally blank during the daily
operation of the machine. The display is ac tivated
when the SEL s ymbol or the Manager’s Menu is
selected. The display screen will als o alert the
operator of specific faults detected by the control.
Note: The displays illustrated i n this section are
those seen on the Models C708/C709. The Model
C716/C717 versions may vary slightly.
Power Up Memory (In itializing)
The seven segment display should d isplay “00”
during the initializing sequence.
When the machine is powered, the control system
will initialize to perform a system check. The screen
will display “INITIALIZING”. There will be four types
of data the system will check: LANGUAGE,
SYSTEM DATA, CONFIG DATA, and LOCKO UT
DATA.
Language Initialization
The UVC platform supports multiple languages by
keeping specific strings in battery backed RAM.
After power-up or a CPU reset, the strings are
tested to see if the language strings are p resent and
not corrupted. If the strings are present and not
corrupted, initialization continues. Otherwise, the
operator is pr ompted to select a language. While
language strings are being checked for integrity, the
following screen is displayed.
Initializing
Language
Note: If there is a language initialization fault, the
machine will force a language selection prior to the
initializing sequence. The standard menu LED’s
should light, as if i t w ere in a menu. If a l anguage
has been s elected, the unit is power ed down, the
machine should not ask for a language unless there
is another language initialization fault. English is the
factory default setting.