Taylor C708 Freezer User Manual


 
43
Models C708 & C716 Important: Operator Checklist
050808
Section 7 Important: Operator Checklist
During Cleaning and Sanitizing
ALWAYS FOLLOW LOCAL HEALTH CODES.
Cleaning and sanitizing schedules are governed
by your State or local regulatory agencies and
must be followed accordingly. The following
check points should be stressed during the
cleaning and sanitizing operations.
CLEANING AND SANITIZING MUST BE
PERFORMED EVERY TWO WEEKS.
Troubleshooting Bacterial Count
j 1. Thoroughly clean and sanitize the machine
regularly, including complete disassembly and
brush cleaning.
j 2. Use all br ushes supplied for thorough
cleaning. The brushes are specially designed
to reach all m ix pas sageways.
j 3. Use the white bristle brush to c lean the mix
inlet hole w hich ex tends from the mix hopper
down to the r ear of the freezing cylinder.
j 4. Use the black b ristle brush to thoroughly
clean the rear shell bearing located at the rear
of the freezing cylinder and the drive hub
opening in the rear wall of the mix hopper. Be
sure there is a generous amount of cleaning
solution on the brush.
j 5. Properly prepare the c leaning and sanitizing
solutions. Read and follow the label directions
carefully. Too strong of a solution may
damage the parts and too weak of a solution
will not do an adequate job of cleaning or
sanitizing.
j 6. The temperature of the mix in the mix hopper
and walk-in cooler s hould be below 40_F
(4.4_C).
j 7. Discard remaining mix from the freezer during
“Cleaning Procedures”.
Regular Maintenance Checks
j 1. Replace scraper blades that are n icked o r
damaged. Before installing the beater
assembly, be certain that scraper blades are
properly attached to the helix.
j 2. Check the rear shell bear ing for signs of wear
(excessive mix leakage in rear drip pan) and
be certain it is properly cleaned.
j 3. Using a screwdriver and cloth towel, keep the
rear shell bearing and the female hex drive
socket clean and free of lubricant and m ix
deposits.
j 4. Dispose of o-rings and s eals if they are w orn,
torn, or fit too l oosely, and replace with new
ones.
j 5. Follow all lubricating procedures as outlined in
“Assembly”.
j 6. If your machine is air c ooled, check the
condensers for accumulation of dir t and lint.
Dirty condensers will reduce the efficiency
and capacity of the machine. Condensers
should be c leaned monthly with a soft brush.
Never use s crewdrivers or other metal probes
to clean between the fins.
Note: For machines equipped with an air
filter, it will be necessary to vacuum clean the
filters on a monthly schedule.
Caution: Always disconnect
electrical power prior to cleaning the
condenser. Failure to follow this instruction
may result in electrocution.
j 7. If your machine is water cooled, check the
water lines for kinks or leaks. Kinks can occur
when the machine is moved back and forth for
cleaning or maintenance purposes.
Deteriorated or cracked water lines should be
replaced only by an authorized Taylor
distributor.