Filter
Top Products
27
Models C708 & C716 Operating Procedures
USE EXTREME CAUTION when handling
the beater assembly. The scraper blades are v ery
sharp and may c ause injury.
Step 6
Before installing the beater assembly, check the
scraper blades for any nicks or signs of wear . If any
nicks are present, or if the blades are worn, replace
both blades.
If the b lades ar e in good condition, install the
scraper blade clips over the scraper blades. Place
the rear scraper blade over the r ear holding pin on
the beater. (See Figure 15.)