Filter
Top Products
EN
7
Basic settings
Initial Settings
After your steam oven is first plugged in or after a
power failure, the clock display will flash to
indicate that the time shown is not correct.
The oven will not operate until the clock and the
water hardness parameter are set.
To set the clock and the water hardness
parameter value proceed as described in the
following chapters.
Setting the clock
The clock display will flash if your appliance is first plugged in or after a power failure, to indicate that the
time shown is not correct. To set the clock, proceed as follows:
12:30
1
4,6
2,3,5
1. Press the “On/Off” key to switch the oven on.
2. Hold down the “–” and “+” keys simultaneously.
The hour digits will flash (steps 1 and 2 are not
necessary when the oven is first plugged in or
after a power failure).
3. Press the “–” and “+” keys to set the hours.
4. Press the OK key to confirm the hours. The
minutes digits will flash.
5. Press the “–” and “+” keys to set the minutes.
6. Press the OK key to confirm the minutes.
Water Hardness setting
1 2
2
43
The appliance features a system that
automatically indicates when it is time to descale.
The system can be optimised for households with
very soft water (also through using a water
softening appliance) and very hard water, by
changing the user settings to the relevant range of
water hardness (see table below).
To set the water hardness parameter, proceed as
follows:
1. Press the “On/Off” key to switch the oven on.
2. Press the “Left” and “Right” keys at the same
time. The hardness grade will start to flash on
the display (steps 1 and 2 are not necessary if
your microwave oven is first plugged in or after
a power failure).
3. Press the “–” and “+” keys to set the correct
water hardness parameter value, according to
the below table.
4. Press the “OK” key to set the parameter. The
display shows the clock.