Filter
Top Products
6712SR Refrigerated Sampler
Section 4 Standard Programming
4-23
Figures 4-5, 4-6, 4-7, 4-8, and 4-9 show examples of reports con-
figured to show program settings, sampling results, combined
results, and a summary report.
(The Source and Error Codes Listed below refer to why a sample was taken and what happened while it was
being taken.)
Source Codes
*C Calibrate sample Sample volume delivered during calibration.
*D Disable Sample event at disable time.
*E Enable Sample event at enable time.
Ev Event Event-paced sample event.
*F Flow Flow-paced sample event.
*G Grab sample Sample volume delivered as a grab sample.
M Command driven
sample
A command driven sample.
PH Phone command Phone command sample.
R Resume Sample event at resume time.
*S Start Sample event at start time.
Sw Switch time Sample event at switch time.
TO Time Override Sample event at bottle-switch time.
*T time Time-paced sample event.
Error Codes
*DJ Distributor Jammed The distributor jammed.
*IP sample in progress Sample in progress when report was printing.
*L pump latch open Unable to take sample because the pump band was opened.
*ND no distributor arm There is no distributor arm or the stop is damaged.
*NL No Liquid Detected The sampler was unable to detect liquid.
LF Not enough flow Not enough flow for the minimum sample volume entered for samples with vol-
umes
proportional to flow.
*NM No More Liquid After the sampler detected liquid and while the sample was being taken, the liquid
detector stopped detecting liquid.
M Bottle Full The composite bottle is full.
*O Sampler Shut Off The sampler was turned off with the On-Off key during the sample event.
Ov Probable Overflow The sampler was directed to take a sample that would not fit into the bottle. Occurs
for flow paced, time override programs only.
*P Power Failed The power supply failed during the sample event. Note: Power failures during five
consecutive sample events results in a LOW BATTERY shut-down.
*PJ Pump Jammed The pump jammed.
*Sk Sample Skipped Sample not taken.
*US User Stopped You pressed the Stop key during the sample event.
Table 4-3 Reports: Program Events, Source Codes, and Error Codes (Continued)