Filter
Top Products
SCREENING CALLS
14
Design
■
Features
■
Performance
The ice cubes are sticking together! - U-CO29FF, CO2075FF and BI•2015
Models Only
• BI•2015 Model Only - Does the unit need to be defrosted?
• Is the door sealing properly? This could cause the ice cubes to stick together.
• Have you tried to shake the ice bucket? If the ice sits without being used, it will tend to stick together.
Shaking the bucket will usually break apart the ice cubes. If the ice has been sitting for a long time, we
recommend dumping the bucket and making fresh ice.
• CO2075FF, U-CO29FF - Turn freezer control colder.
Water is leaking out of the unit! - U-CO29FF, CO2075FF and BI•2015
Models Only
• Have you checked the connection at the water solenoid valve? U-Line’s warranty does not cover
installation adjustments.
No ice or not enough ice! - U-CO29FF, CO2075FF, BI•2015 and CLR2060
Models Only
• Are you aware of the factory specifications for ice production?
Model # Approx. Daily Ice Rate Approx. Ice Storage
CO2075FF, U-CO29FF 8 lbs. 13 lbs. bucket
CLR2060 60 lbs. 35 lbs. bucket
BI•2015 25 lbs. 25 lbs. bucket
• Is the ice maker bin arm down? When the arm is up, it will not make ice.
• Is the door sealing properly? U-Line’s warranty is 90 days for door adjustments.
• Does the water level need to be adjusted? U-Line’s warranty is 90 days for water level adjustments.
• BI•2015 Model Only - Is the temperature control set to the warmest setting? The unit will produce the
most ice when set at the warmest setting. Let the unit run overnight.
• CO2075FF, U-CO29FF - Turn freezer control colder.
My cubes are wet - CLR2060 Model Only
• The storage bin that holds the ice is not refrigerated. The cubes in the bin are slowly melting down.
The bin will maintain a temperature of 32 to 34 degrees.
The floor is very warm in front of my CLR2060 Model
• The unit is designed for a built-in application, so the warm air will discharge out the bottom of the unit
below the door. There is a safety feature built into the control board that will shut the unit down if the
warm air cannot be dissipated.
No ice, water pours into the trough and down into the drain - CLR2060
Model Only
• The standpipe needs to be inserted into the drain hole of the water trough to maintain the proper level
of water inside the trough.
CUSTOMER
COMPLAINT
CUSTOMER
COMPLAINT
CUSTOMER
COMPLAINT
CUSTOMER
COMPLAINT
CUSTOMER
COMPLAINT
CUSTOMER
COMPLAINT