Filter
Top Products
78
Design
■
Features
■
Performance
BI•2015 REPLACING ICE MAKER ASSEMBLY
1. Unplug unit.
2. Disconnect ice maker wire harness at plug (1).
3. Remove control capillary tube from sensing tube on ice maker assembly (2).
4. Remove water inlet tube.
5. Remove front cover (3).
6. Advance ejector blade to the 3 o’clock position by turning the 5/16" hex head on the small brass gear
counterclockwise (4).
7. Remove two screws from wall of freezer housing (5).
8. Remove three screws (6) from bottom of evaporator shelf.
9. Remove ice maker assembly.
10. Remove old alumilastic compound from evaporator shelf.
11. Apply 1/4" of fresh alumilastic compound to the bottom of the new ice maker assembly.
12. Install new ice maker assembly.
13. Reconnect plug.
14. Insert control capillary tube into ice maker sensing tube.
15. Insert water inlet tube.
16. Apply Permagum to all exit holes.
17. Install back panel.
18. Plug in unit and test.
1
2
5
4
6
3
U-LINE1001A
BI•2015 MODEL