Filter
Top Products
The diagnostic LED shown below will specify the following:
1. One Flash - Indicates the overflow protection circuit is open (only on P-60 pump equipped
units).
2. Two Flashes - Indicate an open thermistor or out of range (too warm) problem.
3. Three Flashes - Indicate the unit has both failure conditions above.
Note: Interrupting power to the board is the only method of clearing the error codes. Switching off the
ON/OFF/CLN switch does not clear the codes.
CLR2060 BOARD
Part# 68003
E_SP-003
This LED will
be used to displa
y
error codes.
COMPRESSOR
WATER
VALVE
HOT
GAS
H O
PUMP
FAN
2
Not a relay
INTRODUCTION
98
Design
■
Features
■
Performance