Filter
Top Products
– 11 –
GAS BURNERS
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
Shut off the gas before servicing
the oven.
1. Remove the lower front cover as outlined
under Covers and Panels.
2. There are two burners located on the bottom
left and right side of the oven. Disconnect the
ignition cable and the flame sense lead from
each burner.
3. Remove the bolts securing the gas manifold
and place manifold aside.
4. Grasp the burner and lift out.
5. Reverse the procedure to install and check
for proper operation.
A. Ensure the spacers are in place on the
ignition wires. The spacers are intended
to keep the ignition wires from laying flat
on the oven chassis.
B. Ensure that the bracket on the back of
the burner is inserted into the slot at the
rear of the burner chamber.
Note: Check the flame current by following the Flame
Current Measurement procedures under the
Procedures and Adjustments Section of this manual.