Filter
Top Products
– 16 –
7. The top and bottom bearings are now
accessible for inspection and/or replacement
if needed.
A. If bearings are OK, proceed to step 8.
B. If replacing the top bearing, remove the
top bearing retainer and top bearing.
C. If replacing the bottom bearing, remove it
from the door shaft or the lower sill
opening.
8. Reverse procedure to install door assembly
and check for proper operation as outlined
under the Door Adjustment and Door Switch
Adjustment section in Procedures and
Adjustments.
ROLLER LATCH ASSEMBLY
(INDEPENDENT DOORS)
NOTE: For units with serial number starting with 48
made after 8/12/07 and serial number starting with 54
made after 8/26/07.
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove the screws that attach roller latch
assembly to door.
2. Reverse procedure to install.
DOOR WINDOW
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove the screws at the top and bottom of
the door.
GLASS
REMOVE
SCREWS
OVEN CAVITY
PL-56052
DOOR CATCH ROLLER ASSEMBLY
(INDEPENDENT DOORS)
NOTE: For units with serial number starting with 48
made before 8/13/07 and serial number starting with
54 made before 8/27/07.
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove the top front cover as outlined under
COVERS AND PANELS.
2. Remove the nuts and bolts that secure the
door catch assembly.
3. Reverse the procedure to install.
4. Adjust the roller catch as outlined under the
Door Catch Adjustment in Service Procedures
and Adjustments.