Filter
Top Products
– 28 –
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Check the doors to make sure they have an
equal gap between them and that the vertical
edge of the door is parallel to the vertical door
seal. If the doors are not positioned in this
manner, adjust the doors as described.
EQUAL GAP
EQUAL GAP
PL-56059-1
EQUAL GAP
2. Remove the top front cover.
3. Loosen the screws that secure the upper door
bearings and related hardware, just enough to
allow door movement.
4. Move the door until proper alignment is
achieved, then tighten the screws on the
upper door bearing hardware.
5. Repeat steps 3 and 4 on the opposite door if
necessary.
6. If one door is higher than the other, add or
remove shims under hinge pin as needed.
DOOR
SHAFT
UPPER
BEARING
LOOSEN
SCREWS
PL-56060
DOOR ADJUSTMENT
DOOR STRIKE ADJUSTMENT
(INDEPENDENT DOORS)
NOTE: For units with serial number starting with 48
made after 8/12/07 and serial number starting with 54
made after 8/26/07.
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove the top front cover as outlined under
COVERS AND PANELS in REMOVAL AND
REPLACEMENT OF PARTS.
2. Open the doors and inspect the door strike for
proper shape.
A. Replace if bent. Do not bend strike plate.
B. If adjustment is necessary, loosen
fasteners, close doors and insure contact
between the door inner surface and upper
horizontal seal. Slide door strike plate
until contact with roll latch is made.
Tighten strike plate fasteners.
3. Open and close the doors several times while
observing the roller latch and strike plate
operation.
A. Replace roller latch if malfunctioning as
outlined under ROLLER LATCH
ASSEMBLY (INDEPENDENT DOORS)
and adjust as outlined in this procedure.
4. Each oven door should be open with a force
of 8 to 25 pounds when pulled at the handle.
The adjustments must allow the doors to
remain closed during normal operation and
allow opening without exertion by the user.