Filter
Top Products
ELECTRIC COMBI OVEN - REMOVAL AND REPLACEMENT OF PARTS
Page 12 of 68
3. Release the clips on the back of the mounting
rail.
4. Reverse procedure to install.
BLOWER AND MOTOR
WARNING:
DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
Removal
1. Remove the rack guide, filter and exhaust
assembly as outlined under “RACK GUIDE/
FILTER/EXHAUST ASSEMBLY”.
2. Loosen bolt (one turn) that secures the blower
and install puller.
3. Tighten the puller, then tap the puller with a
hammer to loosen the blower from the motor
shaft.
4. Remove the puller, bolt, washer and blower
from the motor shaft.
NOTE:
If only the blower is being removed, reverse
the procedure at this point to install.
5. Remove the rear panel as outlined under
“COVERS AND PANELS”.
6. Disconnect the lead wires from the motor.
7. Remove the motor from the back of the oven
by removing the mounting nuts.
8. Remove the cover plate and seal from inside
the oven cavity.
NOTE:
You may have to drive the seal out from the
back of the oven.