Watlow Electric 2000 Microwave Oven User Manual


 
30 Watlow MINICHEF 2000 Application 3
If the Hold time parameter [Htine] has been set to 0, the unit will count up time
indefinitely. The hold sequence will end and the controller will go into idle when you
cancel the current menu by pressing the active menu key.
If [Htine] is greater than 0, the unit will run the hold sequence until the hold time
expires. It will then switch to the sequence described in 4.
4. When the cooking cycle is finished, one of the following will happen, depending on
the way the controller was programmed at [Etype] / [sound]:
With Sound set to 0: The controller automatically switches to idle, in which the con-
troller does not maintain temperature and does not run time. [`idle] or current
time will appear on the display. The menu key indicator light will be off.
With Sound set to 1, 2, or 3: [``end] will appear on the display and an audible tone
will be emitted. The menu key indicator light will flash rapidly. You can acknowl-
edge the tone by pressing the active menu key or it will time out in 1 to 20 seconds
and go into idle.
With Sound set to 4 or 5: [``end] will appear on the display and the menu key
indicator light will flash rapidly. You must acknowledge the audible signal by press-
ing the active menu key. Once acknowledged the audible signal is silenced and the
controller goes into idle.
5. Once the controller goes into idle, the menu key indicator light and the heat outputs
will switch off. The controller will not regulate to any temperature.
6. To repeat cooking, repeat steps 1 through 3 or 4.
Run a Menu (without preheat feature)
This procedure describes how to run an active menu when the preheat function is inac-
tive — in other words, when the [ready] parameter in the [SetUp] function of the
Configuration Mode is set to [```no].
1. With idle on the display, place the food in the oven.
DE
C
F
MINICHEF 2000
[`idle]
Edit Accept
Back-UpExit
DE
C
F
MINICHEF 2000
[`0009]
Edit Accept
Back-UpExit
AB
GH
AB
GH
STEADY
ON
B
DE
C
F
MINICHEF 2000
[`idle]
Edit Accept
Back-UpExit
G H
A
SLOW
FLASH
DE
C
F
MINICHEF 2000
[``EnD]
Edit Accept
Back-UpExit
B
DE
C
F
MINICHEF 2000
[`idle]
Edit Accept
Back-UpExit
G H
AAB
GH
SLOW
FLASH