Filter
Top Products
Application 4 Watlow MINICHEF 2000 ■ 41
Setpoint 1 and Fan 1 will run until Time 1 expires.
Setpoint 2 and Fan 2 will run until Time 2 expires. You will not see the switch-over
from Time 1 to Time 2.
4. Once the cooking sequence is complete, the unit will switch to the Hold sequence.
The display will alternate slowly between [`Ho1d] and count up time.
If the Hold time parameter [Htine] has been set to 0, the unit will count up time
indefinitely. The hold sequence will end and the controller will go into idle when you
cancel the current menu by pressing the Start/Stop key.
If [HtinE] is greater than 0, the unit will run the hold sequence until the hold
time expires. It will then switch to the sequence described in 5.
5. When the cooking cycle is finished, one of the following will happen, depending on
the way the controller was programmed at [Etype] / [sound] :
With Sound set to 0, the controller automatically switches to idle in which the con-
troller does not maintain temperature and does not run time. idle or current time
will appear on the display. The Start/Stop key indicator light will be off.
With Sound set to 1, 2, or 3, [``end] will appear on the display and an audible
tone will be emitted. The Start/Stop key indicator light will flash rapidly. You can
acknowledge the tone by pressing the Start/Stop key or it will time out in 1 to 20
seconds and go into idle. The Start/Stop key indicator light will flash slowly.
With Sound set to 4 or 5, [``End] will appear on the display and the Start/Stop
key indicator light will flash rapidly. You must acknowledge the audible signal by
pressing the Start/Stop key. Once acknowledged the audible signal is silenced and
the controller goes into idle. The Start/Stop key indicator light will flash slowly.
6. Once the controller goes into idle, the Start/Stop key indicator light and the heat
outputs will switch off. The controller will not regulate to any temperature.
7. To repeat cooking, repeat steps 1 through 4 or 5.
Pause a Menu
While cooking, you can pause cooking time by pressing the Start/Stop key once. The
Start/Stop key indicator light will flash rapidly. [PAUSE] will appear on the display.
Countdown time will resume when you press the active menu key again.
Cancel a menu
Canceling a menu stops the controller completely. The controller does not maintain set
point temperatures or run time. You cancel a menu to run another menu, stop menu
operation for any reason, or are preparing to shut off the oven.
• Press the Start/Stop key for 2 seconds (in hold, momentarily press the Start/Stop
key). Heat outputs will switch off. Heat output indicator lights will switch off.
[`idLE] or time of day will be on the display.
Change Menus or Restart
With the controller in idle:
1. Select a menu as shown earlier.
2. Press the Start/Stop key.