Filter
Top Products
52 ■ Watlow MINICHEF 2000 Application 5
If the preheat condition has not been met, the oven will preheat until [ready]
appears on the display.
Note: You can skip preheat and go directly to the cooking sequence by pressing the Start/Stop key a second time.
If the oven is already at operating temperature [ready] will appear on the display.
3. With [ready] on the display, place the food in the oven and insert the meat probe.
Then press the Start/Stop key (indicated by the rapidly flashing indicator light).
The Start/Stop key indicator will light up. Time will count down on the display.
Depending on the way the controller was programmed at [Etype] / [Steps] the
menu will run in one step or two.
One Step
Countdown time is displayed.
Set point 1 will run until time expires.
Two Step
Countdown time is displayed. It is the total of the programmed Time 1 plus Time 2.
Set point 1 will run until Time 1 expires.
Set point 2 will run until Time 2 expires. You will not see the switch-over from Time
1 to Time 2.
4. When the cooking sequence is complete, the oven will run the probe sequence.
[ProbE] will appear on the display.
The unit will continue to cook until the food reaches the programmed probe temper-
ature.
5. Once the cooking sequence and probe sequence are complete, the unit will switch to
the Hold sequence.
An audible tone will sound for two seconds.
The display will alternate slowly between [`Ho1d] and count up time.
The unit will count up time indefinitely. The hold sequence will end and the con-
troller will go into idle when you cancel the current menu by pressing the Start/Stop
key.
6. Once the controller goes into idle, the Start/Stop key indicator light will switch off.
7. To repeat cooking, repeat steps 1 through 5.
Run a Menu (with no preheat feature)
This procedure describes how to run an active menu when the preheat feature is inac-
tive (when the [ready] parameter in the [setUp] function of the Configuration mode
is set to [```no]).
1. Select the menu you want to run as shown earlier.
2. With idle on the display, place the food in the oven and insert the meat probe.
3. Press the Start/Stop key.
The Start/Stop key indicator will light up. Time will count down on the display.