Filter
Top Products
72 ■ Watlow MiniChef 2000 Application 16
the display. (The message, which varies based on programming at [M```] /
[ALArn] will appear for ten seconds.)
An audible tone will sound for five seconds. Time will continue to count down on the
display.
4. When the cooking cycle is finished one of the following will happen, depending on
the way the controller was programmed at [EtypE] / {Sound].
With Sound set to 0: The controller automatically switches to idle, where the con-
troller maintains the temperatures at set point and does not run time. [`idle] or
time of day will appear on the display. The menu key indicator light will flash slow-
ly.
With Sound set to 1, 2, or 3, [``End] will appear on the display and an audible tone
will be emitted. The menu key indicator light will flash rapidly. You can acknowl-
edge and silence the tone by pressing the active menu key or it will time out in 1 to
20 seconds and go into idle. The menu key indicator light will flash slowly.
With Sound set to 4 or 5, [``End] will appear on the display and the menu key
indicator light will flash rapidly. You must acknowledge the audible tone by pressing
the active menu key. Once acknowledged, the tone is silenced and the controller
goes into idle The menu key indicator light will flash slowly.
5 Remove the food from the fryer. The controller will continue to regulate to the last
set point. The menu key indicator light will flash slowly.
6. To repeat cooking, repeat steps 1 through 5.
Run a Menu (without preheat feature)
This procedure describes how to run a menu when the preheat function is inactive —
that is, when the [Ready] parameter in the [SetUp] function of the Configuration
Mode is set to [```no] — and initial preheat power-up has been completed.
1. With [`idle] on the display, place the food in the fryer.
2. Press the key for the menu you want to run. The menu key will light up and then
time will count down on the display.:
3. If programmed, as the time counts down, a mid-menu alarm message [M```] /
[ALArn] will appear on the display.
The alarm message, which varies based on programming, will appear for ten sec-
onds.
An audible tone will sound for five seconds. Time will continue to count down on the
display.
4. When the cooking cycle is finished one of the following will happen, depending on
DE
C
F
MINICHEF 2000
[`idle]
Edit Accept
Back-UpExit
DE
C
F
MINICHEF 2000
[`0009]
Edit Accept
Back-UpExit
B
DE
C
F
MINICHEF 2000
[`idle]
Edit Accept
Back-UpExit
G H
A
AB
GH
AB
GH
DE
C
F
MINICHEF 2000
[alert]
Edit Accept
Back-UpExit
AB
GH
STEADY
ON
SLOW
FLASH
DE
C
F
MINICHEF 2000
[``EnD]
Edit Accept
Back-UpExit
B
DE
C
F
MINICHEF 2000
[`idle]
Edit Accept
Back-UpExit
G H
AAB
GH
RAPID FLASH
IF PROGRAMMED
SLOW FLASH