Filter
Top Products
1-16
air shutter
gas orifice
locking screw
bake burner
venturi
oven base
7. Turn the oven control knob to OFF. When the
oven cools, reinstall the heat shield, the oven
floor, and the oven racks.
3. Remove the screws from the heat shield over
the bake burner and remove the shield.
heat shield
screws
screws
4. Push and turn the oven selector control knob
for a setting of 350˚F. The oven burner should
light in 50- to 60-seconds (the delay is due to
the time it takes for the gas valve to open and
the gas to flow to the burner).
CHECKING THE OVEN BURNER OPERATION
5. Check the flame coming from the burner bar.
If the flame is noisy, or is blowing away from
the bar, there is too much air during combus-
tion. If the flame is soft and not high enough,
there is not enough air. If either of these
conditions occur, proceed to the next step.
6. With the burner lit, loosen the locking screw,
and adjust the venturi air shutter opening for
the best flame, then retighten the locking
screw.
THE BAKE BURNER
NOTE: The bake burner may be controlled by a
knob, or an electronic keypad. Refer to the oven
control that is used on the range you are testing.
Control Knob
1. Remove the oven racks.
2. Remove the two screws from the oven floor
and remove the floor.