Filter
Top Products
3-22
REMOVING THE GAS SAFETY VALVE &
PRESSURE REGULATOR
WARNING
4. From behind the range, disconnect the four
wires and the gas line fittings from the gas
safety valve and the pressure regulator.
5. Remove the gas safety valve and the pres-
sure regulator from the range.
6. If you are not replacing the complete assem-
bly, separate the gas safety valve from the
pressure regulator, then replace the defective
component. NOTE: Apply pipe sealant that is
recognized by U.L. to the threads of the fitting
before you connect the two components to-
gether again.
7. Mount the new gas safety valve and pressure
regulator assembly to the range with its mount-
ing hardware. NOTE: Make sure that the bake
burner is positioned over the orifice hood.
GAS INLET
BAKE BURNER
GAS SAFETY
VALVE
TO MAINTOP
BURNERS
PRESSURE
REGULATOR
TO BAKE
SHUTOFF VALVE
TERMINALS
TO BROIL
BURNER
GAS SHUTOFF LEVER
BLUE
RED
WHITE
WHITE
MOUNTING
BRACKET
CAUTION: When you work on the gas range, be
careful when handling the sheet metal parts. Sharp
edges may be present, and you can cut yourself if
you are not careful.
Electrical Shock Hazard
Disconnect from electrical supply before servic-
ing unit.
Failure to do so could result in death or electri-
cal shock.
1. Pull the range away from the wall so that you
can access the back.
2. Turn off the gas to the range and disconnect
the power cord from the wall outlet.
3. Remove the bake burner from the oven (see
page 3-23 for the procedure).