Filter
Top Products
3-26
REMOVING A SIDE PANEL
WARNING
NOTE: The range is shown in the illustration on the
next page with the maintop and burners removed
for clarity. Also, the right side panel is shown
removed. The left side panel is removed in the
same manner.
5. Remove the five screws that secure the side
panel to the back of the range.
6. Remove the top screw from the upper console
end cap.
7. Remove the two screws from the burner box
that secure the side panel to the top of the
range.
8. Remove the front control knobs.
9. Open the oven door and remove the three
screws from the bottom of the manifold panel
and remove the panel.
10. Pull the rear of the side panel away from the
range, push the panel forward, and unhook
the three tabs from the slots at the front of the
side panel.
11. Replace the side panel. IMPORTANT REAS-
SEMBLY NOTE: When you install the side
panel, position the top flange
under the
burner box.
12. Reassemble the range.
CAUTION: When you work on the gas range, be
careful when handling the sheet metal parts. Sharp
edges may be present, and you can cut yourself if
you are not careful.
Electrical Shock Hazard
Disconnect from electrical supply before servic-
ing unit.
Failure to do so could result in death or electri-
cal shock.
1. Pull the range away from the wall so that you
can access the back.
2. Turn off the gas to the range and disconnect
the power cord from the wall outlet.
3. Remove the grates from the maintop.
4. Lift the maintop and prop it up (use the proce-
dure on page 3-2 or 3-4).