Filter
Top Products
Replacing
1. Make
sure all surface units are off and
cwl before replaciig surface units and
reflector bowls.
2.
Line up openings in the reflector bowl
with the surface unil receptacle and the
element hokkbwn clip.
3.
Hold the surface unit as
level as possible
with the terminal just started into the
receptacle.
Push the
surface unit terminal
Into the receptacle.
4.
When terminal ls pushed Into the
receptacle as far as It will go, push
down the edge of the surface unit
opposite the receptacle. The element
hold-down clii will keep the surface unit
from moving around.
NOTE: Reflector bowls reflect heat
back to
the utensils on the surface units. They
also
help catch spills. When they are kept clean,
they reflect heat better and bok new longer.
If a reflector bowl gets d&Axed. some of
your rrtensils may not bs
flat
enough, or
some may be too large for the surface unit.
In either case, some of the heat that’s meant
to go into or around
a
utensil goes down and
heats the reflector bowl. This extra heat can
discolor il.
21