Filter
Top Products
15628-9-1007Page 14
Whenever the standard grill top is replaced with a stone inlay
you must install the top shield, which is provided with the stone
inlay.
Installation of Optional Stone Inlay
1. Remove left grill, center grill and right grill from casting top.
2. Remove casting top from casting.
3. Place the casting top on a non-abrasive surface in order to protect
the porcelain finish. The exterior of the casting top should be
facing the non-abrasive surface.
4. Attach 11 5/8" x 11 5/8" top shield to the interior of the casting
top with (1) 3/8" bolt provided in hardware package.
5 Place the casting top onto the casting. The casting top nests
into the casting.
6. Insert center stone inlay, left stone inlay and right stone inlay
into casting top.
7. Installation of stone inlay is completed.
The ON/OFF/REMOTE switch with
harness is factory installed into the wire
channel. After the firebox is installed
into the casting the wire channel can
be installed.
1. Attach channel divider to rear cover
with (2) 10 x 1/2" screws.
2. Attach wire channel to channel
divider with (2) 10 x 1/2" screws.
The wires from ON/OFF/REMOTE
switch will be routed within wire
channel.
3. Attach the green (wire) female
push-on to the TH terminal on gas
valve.
Figure 13
OPTIONAL STONE INLAY INSTRUCTIONS
WIRE CHANNEL INSTALLATION
Stone Inlay Hardware Package Parts List
Part
Description
Part
Number
Quantity
Supplied
11 5/8" x 11 5/8" Top Shield
CI-091 1
3/8" Bolt R-3646 1