Advanced Configuration AP-700 User Guide
Interfaces
47
Interfaces
From the Interfaces tab, you configure the Access Point’s operational mode settings, power control settings, wireless
interface settings and Ethernet settings. You may also configure a Wireless Distribution System for AP-to-AP
communications. The Interfaces tab contains the following sub-tabs:
• Operational Mode
• Wireless A (802.11a/b/g Radio)
• Ethernet
NOTE: On APs with model numbers ending in -WD, the operating country must be selected on the System tab before
any of these sub-tabs are available.
Operational Mode
From this tab, you can configure and view the operational mode for the Wireless interface.
Figure 4-9 Operational Mode Screen
The Wireless (802.11a/b/g) interface can be configured to operate in the following modes:
• 802.11a only mode: The radio uses the 802.11a standard only.
• 802.11b mode only: The radio uses the 802.11b standard only.
• 802.11g mode only: The radio is optimized to communicate with 802.11g devices. This setting will provide the best
results if this radio interface will only communicate with 802.11g devices.
