Advanced Configuration AP-700 User Guide
Interfaces
56
channel is blacklisted automatically if it is found to be busy or occupied by radar during a scan at start-up. When a
channel has been automatically blacklisted, it will remain blacklisted for 30 minutes. Additionally, an administrator can
blacklist channels manually to prevent them from being used when ACS is enabled.
NOTE: Any change in channel-related parameters (e.g., country code, turbo mode, Operational mode, H-band
operation) resets the channel blacklist table.
The channel blacklist table can be configured only through the Web or SNMP interfaces. CLI configuration is not
supported.
To blacklist a channel manually:
1. Click on Configure > Interfaces > Wireless A.
2. Scroll down to the Channel Blacklist heading.
Figure 4-11 Channel Blacklist Table
3. Click Edit in the Channel Blacklist Table
4. Set Blacklist Status to Enable.
