Connecting computers to your interactive flat
panel
You can connect up to three computers simultaneously to your interactive flat panel:
l An installed room computer connected to USB 1 and the VGA
l An installed cable for the guest laptop connected to USB 2and RGB/HV connection
l A side laptop connected to the USB 3and HDMI 2 connector
N OTE
This document describes the default USB and video connections. To customize the USB and video
mapping, see Configuring the video and touch input for your SMART Board 8070i interactive flat
panel (smarttech.com/kb/170065).
Interactive flat panel touch control and video input connections
The following table shows which touch control USB connection corresponds with which video input
for each computer connection.
Touch control Video input
Installation steps
Room computer
USB 1 (inside panel)
VGA page 19
Guest laptop connection USB 2 (inside panel)
RGB/HV page 20
Side laptop connection
USB 3 (side terminal panel)
HDMI 2 page 51
C HA PT ER 3
Connectingcomputersandperipheraldevices
18
