The following safety precautions must be observed during all phases of operation, service and r
this equipment. Failure to comply with the safety p
recautions or warnings in this document violates
safety standards of design, manufacture and intended use of this equipment and may i
Americas Inc. shall not be liable for user’s failure to comply with these
power supply series has been evaluated to INSTALLATION CATEGORY II. Install
category (over voltage category) II: local level, appliances, portable equipment etc. With smaller tra
an Installation Category (over voltage category) III.
This product is a Safety Class 1 instrument. To minimize shock hazard, the instrument chassis must be
connected to an electrical ground
. The instrument must be connected to the
supply mains through a three conductor power cable, with the ground wire firmly connected to an ele
trical ground (safety ground) at the power outlet.
For instruments designed to be hard
wired to the supply mains, the protective earth terminal mu
connected to the safety electrical ground before another connection is made. Any interruption of the
protective ground conductor, or disconnection of the protective earth terminal will cause a potential
shock hazard that might cause personal injury.
Fuses must be changed by authorized
Americas Inc. service personnel only. For conti
tion against risk of fire, replace only with the same type and rating of fuse. Refer to Chapter
e AC supply, which exceeds the input voltage and frequency rating of this instrument. The
input voltage and frequency rating of the Genesys
power supply series is: 190
three phase 200V models and 380
415, 50/60 Hz for three phase 400V m
odels. For safety reasons,
the mains supply voltage fluctu
tions should not exceed +/
Operating personnel must not remove the instrument cover. No internal adjustment or component r
mericas Inc. qualified personnel. Never replace components
with power cable connected. To avoid injuries, always disconnect power, discharge circuits and remove
ternal voltage source before touching components.
PARTS SUBSTITUTIONS & MODIFICATIONS
ubstitutions and modifications are allowed by authorized
nel only. For repairs or modifications, the instrument must be returned to an authorized
Americas Inc. service faci
OUTPUT TERMINALS GROUNDING
There is a potential shock hazard at the RS232/RS485 and the IEEE ports when using power su
with rated or combined voltage greater than 400V and the Positive Output of the Power Supply is
grounded. Do Not connect the
Positive Output to ground when using the RS232/RS485 or IEEE.
