power supplies generate magnetic fields, which might affect
the operation of other instruments. If your equipment is su
magnetic fields, do not position it adj
cent to the power supply.
To avoid electric shock hazard, do not insert co
through the front panel slits.
This Chapter contains instructions for initial inspection, preparation for use and repackaging for shi
ment. Connection to PC, setting the communication port and linking Genesys
In order to be operational the power supply must be connected to an appropriate AC source. The AC
source voltage should be within the power supply specification. Do not apply power before reading
1 below, describes the basic setup procedure. Follow the instructions in Table 3
quence given to prepare the power supply for use.
Initial physical inspection of the power su
Installing the power supply,
Connecting the power supply to the AC source
Wire size selection. Local/Remote sensing. Single
The power supply setting at shipment.
Prior to shipment this power supply was inspected and found free of mechanical or electrical defects.
Upon unpacking of the power supply, inspect for any damage, which may have occurred in transit.
The inspection should confirm that there is no ex
terior damage to the power supply such as broken
knobs or connectors and that the front panel and meters face are not scratched or cracked. Keep all
packing material until the inspection has been completed. If damage is detected, file a claim with ca
immediately and notify the
sales or authorized service facility nearest
series is intended only for installation in Restricted
Access Location (RAL). Access to Hazardous parts (rear side of
the power supply) shall be prevented after i
