*1: Minimum voltage is guarantee
d to maximum 0.2% of the rated output voltage.
rent is guaranteed to maximum 0.4% of the rated output current.
*3: For cases where conformance to various safety standards (UL, IEC etc.) is required, to be
Phase 200V models: at 200Vac input voltage
Phase 400V: at 380Vac input voltage. With rated output power.
*5: Not including EMI fil
load, constant input voltage. Measured at the
300V models: measured with J
For 600V model: measured with 10:1 probe.
to 10% of rated output voltage, with rated, resistive load.
*10: From 90% to 10% of rated output voltage.
*11: For load voltage change, equal to the unit v
oltage rating, constant input voltage.
V models the ripple is measured at 2V rated output voltage and rated output current.
For other models, the ripple is measured at 10
100% of rated output voltage and rated output
urrent programming readback and monitoring accuracy does not include the
nd load regulation thermal drift
2.12 SUPPLEMENTAL CHARACTERISTICS
The supplemental characteristics give typical but non
warranted performance characteristics. Th
supplemental characteristics are useful in a
sessing applications for the power supply. Several kinds
of supplemental characteristics are listed below.
Evaluation Data: Typical performance of the power supply.
Reliability Data: Reliability Performance of
EN61000 Data: Performance of the power supply under EN61000 test conditions.
EMI Data: Typical EMI (conducted and radiated) performance of the power su
The supplemental characteristics data is held in each
