1: Front Panel Controls and Indicators
4 digit, 7 segment LED display. Normally displays the ou
Current. When the PREV button is pressed, the display i
dicates the programmed setting of
Green LED, lights for Constant
High resolution rotary encoder for adjusting the Output Cu
rent. Also selects the Baud
Output ON/OFF control. Press OUT to set
the output On or Off. Press to reset and turn On the ou
after OVP or FOLD alarm events have occurred.
ess and hold OUT button to toggle
Restart”. The VOLT display
will cycle between “SAF” and “AUT”. Releasing the OUT
button while one of the modes is displayed, selects that
en the DC output is enabled.
: Go to local. Press REM/LOC to put the unit
into Local mode (REM/LOC button is disabled at Local
Address and Baud Rate setting. Press
3 sec. to set the Address with the
VOLTAGE encoder and the Baud Rate with the CURRENT
Green LED, lights when the unit is in Remote mode.
Foldback protection control.
To release Foldback alarm event, press OUT to e
Press FOLD again to cancel the Foldback protection.
Green LED, lights when Foldback protection is On.
Over Voltage Protection and Under Voltage limit se
Press once to set OVP using VOLTAGE encoder (the cu
rent display shows “OUP”)
Press again to set the UVL using VOLTAGE encoder (the
current display shows “UUL”).
Press PREV to display the Output Voltage
and Current setting. For 5 sec. the display will show the se
ting and then it will return to show the actual Output Voltage
Front Panel Lock. Press and hold
to toggle between “Locked front panel” and
“Unlocked front panel”. The display will cycle b
and “UFP”. Releasing the PREV button while one of the
modes is displayed selects that mode.
