Filter
Top Products
Epson PowerLite 7900p Projector
22 - Epson PowerLite 7900p Projector 9/04
6. To remove the lamp cover, insert the screwdriver supplied
with the spare lamp (or another flat-tipped screwdriver),
into the space beside the air vent to gently lift the lamp
cover off.
7. Loosen the two screws holding the lamp in place. (You
don’t need to remove them.)
8. Grasp the wire handle as shown and pull the lamp straight
out.
9. Gently insert the new lamp.
10. Once the lamp is fully inserted, tighten its screws and
replace the cover. (The projector won’t come on if the lamp
cover is loose.)
11. Reset the lamp timer as described in the next section.
Resetting the Lamp Timer
After you replace the lamp, you need to reset the lamp timer
using the projector’s About menu.
1. Press the
Menu button on the remote control or the
projector’s control panel to display the main menu.
2. Use the pointer button on the remote control (or the
arrow buttons on the projector) to highlight
About, then
press
Enter.
You see this screen:
Note: The lamp usage timer shows
0H until you’ve used the
lamp for at least 10 hours.
3. Select
Reset Lamp
Timer
. You see this
prompt:
4. Select
Yes.
5. When you’re finished, press
ESC or Menu to exit.
Transporting the Projector
The projector contains many glass and precision parts. Follow
these guidelines to prevent injury or damage when
transporting it:
❏ When hand-carrying the projector, you should use the
handle to carry it only a short distance (for example, to set
it on a table).
❏ When shipping the projector for repairs, use the original
packaging material if possible. If you do not have the
original packaging, use equivalent materials, placing plenty
of cushioning around the projector.
❏ When transporting the projector a long distance, first place
it in a hard-shell shipping case, and then pack it in a firm
box, placing cushioning around the case. (An optional ATA
shipping case is available from Epson; see the following
table.)
1
Insert the screwdriver here
Video
Video
Audio
Audio
Setting
Setting
User's Logo
User's Logo
Advanced1
Advanced1
About
About
Reset All
Reset All
Frequency
Frequency
Video Source
Video Source
V ---.---Hz
V ---.---Hz
Reset Lamp Timer
Reset Lamp Timer
H ---.---kHz
H ---.---kHz
Lamp
Lamp
1400H
1400H
SYNC Mode
SYNC Mode
SYNC Polarity
SYNC Polarity
------
------
V ------
V ------
H ------
H ------
Resolution
Resolution
Refresh Rate
Refresh Rate
---.-- Hz
---.-- Hz
----x ----
----x ----
Computer1
Computer1
Input Signal
Input Signal
:
:
:
:
:
:
:
: Analog-RGB
Analog-RGB
Execute
Execute
[ ]: Select
[ ]: Select
[ ]: Enter
[ ]: Enter
[Menu]: Exit
[Menu]: Exit
Effect
Effect
Advanced2
Advanced2
Lamp usage