Filter
Top Products
Epson PowerLite 7900p Projector
9/04 Epson PowerLite 7900p Projector - 7
2. Click the
Arrange icon.
3. Drag one monitor icon on top of the other.
If the Arrange option isn’t available, you may need to select
one of the Simulscan resolution settings:
1. Click the
Monitor icon.
2. Select a
Simulscan resolution as shown. (Allow a few
seconds for the projector to sync up after making the
selection.)
Adjusting the Image
Once you see your image, you may need to make certain
adjustments.
Focusing and Zooming Your Image
Use the Focus ring on the projector to sharpen the image.
Use the Zoom ring on the projector to reduce or enlarge the
projected image. Move the tab toward the
W to make it
bigger, or toward the
T to make it smaller.
If the image still isn’t large enough, you may need to move the
projector farther away from the screen. You can also use the
E-Zoom buttons on the remote control to zoom in on a
portion of the image.
Adjusting the Height of Your Image
If the image is too low on the screen, you can raise it by
adjusting the front foot:
1. Stand behind the projector. Press the blue foot release lever
up and lift the front of the projector.
2. Once the image is positioned where you want it, release the
lever to lock the foot in position.
3. If necessary, you can fine-
tune the height by turning
the projector’s rear feet.
Raising the projector may cause the image to distort or
“keystone.” See the next section to correct this.
Adjusting the Image Shape
In most cases, you can maintain a rectangular image by
placing the projector directly in front of the center of the
screen with the base of the lens level with the bottom of the
screen.
Even if the projector is slightly tilted (within a range of 40° up
or down), the projector’s automatic keystone correction
function detects and corrects vertical keystone distortion.
Click here
Drag one monitor
icon on top of
the other
Select a
Simulscan
resolution
Click here
Focus ring Zoom ring
Rear projector foot
Corrected imageProjector tilted up Projector tilted down