Filter
Top Products
B-31
User Guide for Cisco Security Manager 3.0.1
OL-8214-02
Appendix B Site-to-Site VPN User Interface Reference
Create VPN Wizard
Interface Towards Provider Edge Available only when a 2-Box solution is selected.
The VRF forwarding interface on the IPSec Aggregator towards the
PE device.
Note If the IPSec Aggregator (hub) is a Catalyst VPN service
module, you must specify a VLAN.
Interfaces and VLANs are predefined interface role objects. If
required, you can click Select to open a dialog box that lists all
available interfaces, and sets of interfaces defined by interface roles,
in which you can make your selection, or create interface role
objects. For more information, see Interface Roles Page,
page C-126.
Routing Protocol Available only when a 2-Box solution is selected.
Select the routing protocol to be used between the IPSec Aggregator
and the PE.
If the routing protocol used for the secured IGP differs from the
routing protocol between the IPSec Aggregator and the PE, select
the routing protocol to use for redistributing the routing to the
secured IGP.
The options are BGP, EIGRP, OSPF, RIPv2, or Static route.
For information about protocols, see Chapter 12, “Managing
Routers”.
AS Number Available only when a 2-Box solution is selected.
Enter the number that will be used to identify the autonomous
system (AS) area between the IPSec Aggregator and the PE.
If the routing protocol used for the secured IGP differs from the
routing protocol between the IPSec Aggregator and the PE, enter an
AS number that will be used to identify the secured IGP into which
the routing will be redistributed from the IPSec Aggregator and the
PE. This is relevant only when GRE or DMVPN are applied.
The AS number must be within the range 1-65535.
Table B-11 Edit Endpoints Dialog Box > VRF Aware IPSec Tab (continued)
Element Description