Filter
Top Products
Appendix B Site-to-Site VPN User Interface Reference
Site to Site VPN Policies
B-66
User Guide for Cisco Security Manager 3.0.1
OL-8214-02
Hello Interval Available only if you selected the EIGRP routing protocol.
The interval between hello packets sent on the interface, from 1 to
65535 seconds. The default is 5 seconds.
Hold Time Available only if you selected the EIGRP routing protocol.
The number of seconds the router will wait to receive a hello
message before invalidating the connection. The range is 1-65535.
The default hold time is 15 seconds (three times the hello interval)
Delay Available only if you selected the EIGRP routing protocol.
The throughput delay for the primary route interface, in
microseconds. The range of the tunnel delay time is 1-16777215.
The default is 1000.
Failover Delay Available only if you selected the EIGRP routing protocol.
The throughput delay for the failover route interface, in
microseconds. The range of the tunnel delay time is 1-16777215.
The default is 1500.
Hub Network Area ID Available only if you selected the OSPF routing protocol.
The ID number of the area in which the hub’s protected networks
will be advertised, including the tunnel subnet. You can enter any
number. The default is 1.
Spoke Protected Network Area
ID
Available only if you selected the OSPF routing protocol.
The ID number of the area in which the remote protected networks
will be advertised, including the tunnel subnet. You can enter any
number. The default is 2.
Authentication A string that indicates the OSPF authentication key. The string can
be up to eight characters long.
Cost Available if you selected the OSPF or RIPv2 routing protocol.
The cost of sending a packet on the primary route interface. You can
enter a value in the range 1-65535. The default is 100.
Table B-22 GRE Modes Page > DMVPN Policy (continued)
Element Description