Filter
Top Products
El ec tr ic Fryer Op er at io n & Ca re M an ua l • 17
O P E R A T I O N
Careful observation of the finished food product will help
determine optimal filtering frequency. Filtering the
c
ooking oil at regular intervals will help ensure food
quality.
FOR BEST RESULTS
: Do not allow the temperature of
the oil to decrease below the “Idle Mode” temperature of
250°F (121°C) when filtering. If filtering at the end of the
day, pump oil back into the kettle while still hot. Do not
allow oil to cool before returning to kettle.
1. Open the front access door. With the Kettle/Nozzle
selector in the “KETTLE” position, rotate the drain
v
alve counterclock-wise until rotation stops and the
drain valve is in the “OPEN” position. Power to the
main control panel will automatically switch “OFF.”
2. Allow contents of the fryer to completely drain.
3. Press the PUMP “ON” to allow the oil to circulate
through the drain system to flush crumbs. Using the
brushes provided, brush the sides and bottom of the
fryer while the oil is circulating through the system.
Use the angle brush under the heat exchangers.
4. Press the PUMP “OFF” and allow contents of the
fryer to completely drain.
5. Rotate the drain valve clockwise to the
“CLOSED” position.
6. Press the PUMP “ON” and allow the fryer to refill
to the recommended level adding additional
oil/shortening as required to maintain proper fill
level.
7. After the frypot has completely refilled, pull out the
mobile oil trolley and discard the filter into a proper
receptacle. Clean the filter assembly and oil trolley,
if needed.
8. Replace the oil filter and return the trolley to the
proper position beneath the fryer.
9. Press and hold the “ON/OFF” key on
the main control panel for 1-1/2 to 2
seconds to energize the fryer. Continue
normal fryer operation after the preheat
function has been completed.
OIL FILTRATION INSTRUCTIONS (FOR UNITS WITH INSTALLED OPTION)
C A U T I O N
METAL PARTS OF THIS EQUIPMENT
BECOME EXTREMELY HOT WHEN IN
OPERATION. TO AVOID BURNS,
ALWAYS USE HAND PROTECTION
WHEN OPERATING THIS APPLIANCE.
C A U T I O N
OOPPEERRAATTOORRSS MMUUSSTT BBEE MMAADDEE AAWWAARREE OOFF TTHHEE HHAAZZAARRDDSS
IINNVVOOLLVVEEDD IINN TTHHEE OOPPEERRAATTIIOONN OOFF AA HHOOTT OOIILL FFIILLTTEERRIINNGG
SSYYSSTTEEMM.. OONN--SSIITTEE SSUUPPEERRVVIISSIIOONN DDUURRIINNGG TTHHEE
FFIILLTTRRAATTIIOONN PPRROOCCEESSSS AANNDD TTHHEE CCLLEEAANNIINNGG PPRROOCCEESSSS
IISS SSTTRROONNGGLLYY RREECCOOMMMMEENNDDEEDD..
ASF-75E, 120V WITH FILTRATION
OIL
HI-LIMIT
RESET
NOZZLE
KETTLE
SELECTOR
NOZZLE
CONNECTION
MASTER
POWER
SWITCH
ELEMENT
HI-LIMIT
RESET
PUMP
OPEN
CLOSED
KETTLE DRAIN
SELECTOR
NOZZLE
ON
NOZZLE
OFF
ELEMENT
HI
-LIMIT
ALARM
W A R N I N G
TO AVOID PERSONAL INJURY, USE
CAUTION WHEN SURFACES BECOME
SLIPPERY DUE TO SPILLED OR
DRIPPING OIL.