Filter
Top Products
Maintenance
19
Cleaning
WARNING!!
Alway s disconnect the power supply b e-
fore cleaning or servicing the oven.
WARNING!!
If the oven needs to be moved, the gas
must be turned off and disconnected from
the unit before removing the restraint. Re-
connect the restraint after the oven has
been returned to its original location.
Follow this recommended cleaning schedule for
proper oven performance.
Daily:
1. Clean the conveyor belt using a wire brush.Al-
low anyforeign material to drop intothe crumb
pans.
2. Remove the product stop and both crumb
pans from the ends of t he conveyor.
3. Empty and clean the crumb pans with a hot
water/detergent mix. Rinse w ith clean w ater.
Every Three Months:
1. Unplug the 220V power cord.
2. Disconnect the gas. B e sure that the oven
control cables have 2-3 feet of slack
3. Clean the cooling fan louvers on both sides of
theovenwithasoftbrush.
Every S ix Months:
1. Remove the product stop and both crumb
pans from the ends of t he conveyor.
2. Remove both upper end plugs. Loosen the
wing nuts on the bottom of each end plug.
Figure 17
3. Remove the air plates as follows:
a.) Loosen the wing screws holding the air
plate retainers in place. Remove the four
wing screws from the control b ox e nd of
the oven.
Figure 18
b.) Slide the air plates straight out from both
ends of the oven.
Figure 19