Filter
Top Products
18
1
BELT SELECTION
LEFT
WHOPPER
THICK
BURGER
CHICKEN
CENTER RIGHT
SELECT
ENTER
L
1 2 3
C
R
Press and hold for 5 seconds the belt you
wish to change. The Flex Chamber belts are
controlled by the CENTER and RIGHT belt
buttons. For example, press and hold the
CENTER (a) button for 5 seconds.
CHANGING FLEX CHAMBER ELEMENT POWER SETTINGS
The flex chamber on the 9025 uses electric elements on the top and gas burners on the bottom. The elements are divid-
ed into 2 cook zones per belt. These are defined as HEATER 1 (Htr 1) and HEATER 2 (Htr 2). Heater 1 is the front or
feed end elements; Heater 2 is the back or discharge end elements.These zones can be independently controlled. The
heaters are set by percent of power ranging from 0% (OFF), to 100% (full power). NOTE: All elements are factory preset
to 100% power.
SELECT
ENTER
Belt Preset# Time
Center CHICKN 3:45
Htr1 Htr2
100% 100% Exit
2
BELT SELECTION
LEFT
WHOPPER
THICK
BURGER
CHICKEN
SPECIAL 1 SPECIAL 2 SPECIAL 3
CENTER RIGHT
L
1 2 3
65
4
C
R
Then press the product button you wish to
change the power settings for. For example,
press the CHICKEN (a) button.
3
After step 1, the screen will change to the edit
mode with the cursor flashing on the preset
time. Press the
SELECT (a) button to move
the cursor to Htr1 (Heater 1). Use the UP and
DOWN (b) arrows to change the percentage
of power for Htr1 (0%=OFF; 100%=FULL).
When Heater 1 is set, press the SELECT
button to move the cursor to Heater 2. Repeat
to change Heater 2 power setting.
SELECT
ENTER
Left WHOPPR 01:50
Center CHICKN 03:45
Right CHICKN 03:45
FLX XXXX
F MAIN XXXXF
4
When you are finished making changes,
press the ENTER (a) button TWICE (2x) to
save the changes and return to the normal
operating screen.
Cursor
b
a
a
a
a
2x
Nieco Corporation - Model 9025