Filter
Top Products
Cold Drink Center (327/328) Operator’s Guide
August, 2003 Page 4 3280020
Install Options
1. Install the coin box lock:
a. Install the lock cylinder, washer, and nut in the order shown.
b. Tighten the nut.
c. Install the lock bar as shown, and secure with the screw.
2. Mount the base plate brackets:
a. Secure a base plate bracket at each of the remaining pairs of holes with
two of the hex head screws.
3. Mount the base plate and slides:
a. Insert the short arm of the slides into the hinged tabs of the base plate.
Position the slide so the notch near the short arm is on the bottom side.
b. Insert the long arms of the slides into the base plate brackets.
c. Insert a cotter pin through the hole in the back end of each slide. Secure
the pins in place.
d. Push the base plate toward the merchandiser cabinet. The front tab of
the base plate bracket should seat in the notch in the long arm of the
base plate slides.
BASE PLATE
MOUNTING
BRACKET
HEX HEAD
SCREW
COTTER
PIN
LEFT HAND
BASE PLATE
SLIDE
RIGHT HAND
BASE PLATE
SLIDE