Everpure 325 Water Dispenser User Manual


 
Cold Drink Center (327/328) Operator’s Guide
3280020 Page 39 August, 2003
Spritz Drinks
Spritz drinks are special versions of blended drinks that require a slightly different
setup. The idea is to dispense a cold water drink with just a hint of flavoring. An
example would be water with lemon. You can easily do this with a blended setup
by doing the following:
1. Set up all times as you would with a water only drink.
2. Set the and screens to dispense from the same valve.
3. Set the screen to 50%.
4. Alter the syrup timer so that the total syrup throw is only a fraction of a
normal throw (1 or 2 seconds).
5. An alternate technique is to set the first valve to the desired flavor, then set
percent plus to 100%. Either way, all the syrup comes from only one valve,
and the throw time can be adjusted to taste.
CONFIGURE PUMP TYPE
(Supervisor Mode Only)
1. Press , then until the display shows one of the following:
- The machine is configured for CO2 pumps.
- The machine is configured for 50 Hz diaphragm pumps.
- The machine is configured for 60 Hz diaphragm pumps.
NOTE: Machines with diaphragm pumps can only vend one cup size.
2. Press to select the type of pumps in your machine.
NOTE
If you select and press , a decimal will display. This setting
puts the machine into mug only vending. If the machine will not drop cups,
ensure that this setting is not the source of the problem.
3. CONTINUE.