9
Fix the power cable with the clip.
The power cable must be long enough
to allow the appliance to be extracted
from the cabinet to fill the coffee bean
container.
The appliance must be earthed in
compliance with legislation.
Electrical connections must be
performed by a qualified electrician
following the instructions.
Position the appliance on the rails, making
sure the pins are correctly inserted in
the housings, then fix it with the screws
supplied.
If the height of the appliance requires
adjusting, use the spacer disks provided.
If necessary, correct alignment of the
appliance by positioning the spacers
supplied under or at the sides of the
support.
x 16
x 2
Position the rails on the sides of the
cabinet as shown in the figure. Fix with
the screws, then extract them completely.
If the coffee maker is installed over a
warmer drawer, use the top surface of this
as a reference to position the rails.
In this case, there will be no surface to
rest the rails on.
approx. 3
50 mm
x 1
x 4 x 8
x 4
560 + 1
mm
Important!
If you choose Installation option B, you will need to install the lower grill kit BEFORE you install
the coffee maker. Refer to the instructions packed with the lower grill kit.
Installation instructions
EN